The AS2293 Emergency Lighting Exit lighting, Stairways and Fire Places. The AS2293 emergency exit lighting is suitable for use in fire places, stairways, corridors and anywhere there is a need for emergency lighting. The unit features a non-dimmable night light mode with a minimum illumination of 0.1 lux.
The AS2293 is a standard for emergency lighting on stairways, platforms and landings. The device provides illumination for a specified period of time when activated by a fire alarm pull station. The exit signs shall be installed in accordance with the requirements of the building code and local ordinance.
Emergency lighting is an important part of any building’s safety and security systems. When you need to exit the building quickly, it’s vital that you have access to light. This can be achieved using emergency exit lights that are powered by batteries or mains electricity.
The AS2293 emergency exit lighting standard defines the maximum wattage and voltage requirements for emergency exit lights. The standard also specifies the type of bulb and lamp holder required for each type of emergency exit light.
Emergency exit luminaires are required to be located at the entrance of a building. The emergency exit luminaires must be visible from any direction of travel within the building and must provide adequate illumination to allow safe egress.
The emergency exit luminaires must have a minimum luminous intensity of 0.25 foot-candles (fc) measured at the center of the lens, and operate at an average voltage of 120 volts with a frequency of 60 Hertz (Hz).
The system provides illumination sufficient to guide people out of the building in an emergency, but which cannot be seen by an intruder or serve as an aid to someone trying to conceal himself.
The AS2293 Emergency Exit Lighting system consists of turnstiles and control panels that are mounted on walls at each end of the building. At the other end, there is a hallway with a turnstile at either end. When a door is opened, it closes automatically behind the user. This prevents unauthorized access to the area and provides visual confirmation that no one is there before opening the door again.
The switch is activated by an infrared sensor located inside each room or corridor where it will be installed. When someone attempts to enter one of these areas without closing the door behind them, they will be prevented from doing so unless they have activated their infrared receiver prior to entering that room or corridor. This prevents unauthorized access into any other areas in which infrared receivers are installed within this same building.
Emergency exit lighting is a must for any building, whether you’re a commercial or residential facility. It’s not just about safety — it’s also about making sure employees can see the way out during an emergency. The right emergency exit lighting can make all the difference when it comes to ensuring that everyone escapes safely.
Most people have seen emergency exit signs and know what they look like. But what about emergency exit lights? These are different than regular signs in that they actually light up at night when there’s no power. This means they can be used during blackouts or other power failures without being affected by darkness.
Emergency exit lighting is an essential requirement in order to make sure that you can safely access your emergency exits at all times. Most of the time, emergency lights are installed on the ceiling or wall of a building. They are used to provide illumination during night time operations or when there is no electricity in the area.
There are different types of emergency exit lights available in the market today. Some have fluorescent tubes while others use LED bulbs and LEDs are more energy efficient as compared to fluorescent tubes. There are also different types of emergency light fixtures that can be used for emergency exits such as emergency exit signs and luminaires.